Soloist Hardware Manual
2.7.2 Brushless Motor Connections
When you connect a brushless motor that is an Aerotech motor with Aerotech cabling, no
motor phasing process is required.
If you are using an Aerotech brushless motor with the Soloist, see the system
interconnection drawing in Figure 2-9 to determine the motor phase and Hall
connections.
If standard Aerotech brushless motors and cabling are not used, the motor must be
correctly phased, as described in the following section.
Typical motor cables used are the C13802 (BADC-MSO) or BADC-MSONT.
For full cable drawings, refer to your software CD ROM.
Figure 2-9
www.aerotech.com
Motor
Frame
Green/White & Shield
Black
Red
White
Brushless Motor Connections
Installation and Configuration
AC
Brushless
Motor
2-13