Aerotech SOLOIST Hardware Manual page 9

Soloist Hardware Manual
DECLARATION OF CONFORMITY
Manufacturer's Name and Address
Aerotech, Inc.
101 Zeta Drive
Pittsburgh, PA 15238-2897
Declares that the product:
Product Name: Soloist
Conforms to the following product specifications, with the exceptions listed below.
Safety: EN 61010-1:1993
and complies with EMC directive 89/336/EEC and 73/23/EEC low voltage directive.
General notes concerning the test setup.
Safety related requirements to ensure compliance:

Soloist must be installed within an enclosure with construction compliant
unlimited circuits.
Pittsburgh, PA
September, 2004
General notes concerning the test setup.
Safety related requirements to ensure compliance:
Exceptions to EN 61010-1:

Soloist must be installed within an enclosure with construction compliant for
unlimited circuits.

End user is responsible for meeting final protective ground requirements.

AC power disconnect is AC power cord located on front panel of Soloist. End
user is responsible for determining and providing supply disconnect for system.

End user is responsible for preventing unexpected startup.

Connection requirements are described in the technical documentation provided
with the system. End user is responsible for making proper connections and
meeting any required interlock requirements for application.
www.aerotech.com
Safety Requirements
David F. Kincel_________________________
Quality Assurance Manager
Alex Weibel ___________________________
Engineer Verifying Compliance
Regulatory Information
ix