Management Vlan Commands; Network Mgmt_Vlan; Dot1P Commands; Classofservice Dot1Pmapping - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Mode

Management VLAN Commands

network mgmt_vlan

This command configures the Management VLAN ID.
Default
Format
Mode

Dot1P Commands

classofservice dot1pmapping

This command maps an 802.1p priority to an internal traffic class for a device when in 'Global
Config' mode. The number of available traffic classes may vary with the platform. Userpriority
and trafficclass can both be the range from 1-7. Under 'Interface Config' mode, this command
maps an 802.1p priority to an internal traffic class for a specific interface. The command (in either
modes) is only available on platforms that support priority to traffic class mapping on a 'per-port'
basis, and the number of available traffic classes may vary with the platform.
Format
Mode

show classofservice dot1pmapping

This command displays the current 802.1p priority mapping to internal traffic classes for a specific
interface. The slot/port parameter is required on platforms that support priority to traffic class
mapping on a 'per-port' basis.
Platforms that support priority to traffic class mapping on a per-port basis:
Format
Platforms that do not support priority to traffic class mapping on a per-port basis:
Switching Commands
Global Config
1
network mgmt_vlan <1-4094>
Privileged EXEC
classofservice dot1pmapping <userpriority> <traffic-
class>
Global Config or Interface Config
show classofservice dot1pmapping <slot/port>
December 2004, 202-10010-02
8-15