No Set Igmp; Set Igmp; Set Igmp Groupmembershipinterval; No Set Igmp Groupmembershipinterval - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

no set igmp

This command disables IGMP Snooping on the system.
Format
Mode

set igmp

This command enables IGMP Snooping on a selected interface. If an interface which has IGMP
Snooping enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will
subsequently be re-enabled if routing is disabled or port-channel (LAG) membership is removed
from an interface that has IGMP Snooping enabled.
Default
Format
Mode
no set igmp
This command disables IGMP Snooping on a selected interface.
Format
Mode

set igmp groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the system. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface before deleting the interface from the entry. This value
must be greater than the IGMP Maximum Response time value. The range is 1 to 3600 seconds.
Default
Format
Mode

no set igmp groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the system to 260 seconds.
8-50
no set igmp
Global Config
Disabled
set igmp
Interface Config
no set igmp
Interface Config
260 seconds
set igmp groupmembershipinterval <1-3600>
Global Config
December 2004, 202-10010-02
Switching Commands