User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
speed
This command sets the speed and duplex setting for the interface.
Format
Interface Config
Acceptable values are:
100h
100f
10h
10f
speed all
This command sets the speed and duplex setting for all interfaces.
Format
Mode
Acceptable values are:
100h
100f
10h
10f
storm-control broadcast
This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
Switching Commands
speed {{100 | 10} {half-duplex | full-duplex} | 1000
full-duplex}
Mode
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
100BASE-T full duplex
speed all {{100 | 10} {half-duplex | full-duplex} |
1000 full-duplex}
Global Config
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
100BASE-T full duplex
December 2004, 202-10010-02
8-67