Show Users - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Mode
ID
User Name The name the user will use to login using the serial port or Telnet. A new user
may be added to the switch by entering a name in a blank entry. The user name may be up to 8
characters, and is not case sensitive. Two users are included as the factory default, admin and
guest.
Connection From
Idle Time
Session Time

show users

This command displays the configured user names and their settings. This command is only
available for users with readwrite privileges.
on the system.
Format
Mode
User Name
Access Mode
SNMPv3 AccessMode
8-90
Privileged EXEC
Login Session ID
IP address of the telnet client machine or EIA-232 for the serial
port connection.
Time this session has been idle.
Total time this session has been connected.
The SNMPv3 fields will only be displayed if SNMP is available
show users
Privileged EXEC
The name the user will use to login using the serial port, Telnet or
Web. A new user may be added to the switch by entering a name
in a blank entry. The user name may be up to eight characters, and
is not case sensitive. Two users are included as the factory
default, admin and guest
Shows whether the operator is able to change parameters on the
switch (Read/Write) or is only able to view them (Read Only). As
a factory default, admin has Read/Write access and guest has
Read Only access. There can only be one Read/Write user and up
to five Read Only users.
This field displays the SNMPv3 Access Mode. If the value is set
to the SNMPv3 user will be able to set and retrieve
ReadWrite,
parameters on the system. If the value is set to
SNMPv3 user will only be able to retrieve parameter information.
The SNMPv3 access mode may be different than the CLI and
Web access mode.
December 2004, 202-10010-02
the
ReadOnly,
Switching Commands