NETGEAR ProSafe GSM7212 User Manual page 27

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
When the following screen appears, make sure that the port setting are as follows:
4.
Baud Rate:
Data Bits:
Parity:
Stop Bits:
Flow Control:
Figure 3-4: Connection Settings
Click OK.
5.
The HyperTerminal window will open and you should be connected to the switch. If you do not
get a welcome screen or a system menu, press the return key.
When attached to the User Interface via a Telnet Session, the following must be set in order to use
the arrow keys: Under the terminal pull down menu, choose Properties and make sure the VT100
Arrows option is turned on.
Administration Console Telnet Interface
9600
8
None
1
None
December 2004, 202-10010-02
3-3