Show Logging; Show Mac-Addr-Table - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-

show logging

This command displays the trap log maintained by the switch.
The trap log contains a maximum of 256 entries that wrap.
Format
Mode
Number of Traps since last reset The number of traps that have occurred since the last
Number of Traps since log last displayed The number of traps that have occurred
Log
System Up Time
Trap
Note: Trap log information is not retained across a switch reset.

show mac-addr-table

This command displays the forwarding database entries. If the command is entered with no
parameter, the entire table is displayed. This is the same as entering the optional
Alternatively, the administrator can enter a MAC Address to display the table entry for the
requested MAC address and all entries following the requested MAC address.
Format
Mode
8-12
Dynamic VLAN Entries - The number of presently active
VLAN entries on this switch that have been created by GVRP
registration.
VLAN Deletes - The number of VLANs on this switch that have
been created and then deleted since the last reboot.
onds, since the statistics for this switch were last cleared.
show logging
Privileged EXEC
reset of this device.
since the traps were last displayed. Getting the traps by any
method (terminal interface display, Web display, upload file from
switch etc.) will result in this counter being cleared to 0.
The sequence number of this trap.
The relative time since the last reboot of the switch at which this
trap occurred.
The relevant information of this trap.
show mac-addr-table [<macaddr> | all]
Privileged EXEC
December 2004, 202-10010-02
parameter.
all
Switching Commands