Show Spanning-Tree Interface - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Root Path Cost
Root Port Identifier
Root Port Max Age
Root Port Bridge Forward Delay Derived value
Hello Time
Bridge Hold Time
CST Regional Root
Regional Root Path Cost
Associated FIDs
Associated VLANs
When the "brief" optional parameter is included, this command displays spanning tree settings for
the bridge. In this case, the following details are displayed.
Bridge Priority
Bridge Identifier
Bridge Max Age
Bridge Hello Time
Bridge Forward Delay
Bridge Hold Time

show spanning-tree interface

This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot/port> is the desired switch port. The following details are
displayed on execution of the command.
Format
Mode
Port mode
Port Up Time Since Counters Last Cleared Time since port was reset, displayed in
Switching Commands
Value of the Root Path Cost parameter for the common and inter-
nal spanning tree.
Derived value
Configured value
Minimum time between transmission of Configuration Bridge
Protocol Data Units (BPDUs)
List of forwarding database identifiers currently associated with
this instance.
List of VLAN IDs currently associated with this instance.
Configured value.
TConfigured value.
Configured value.
Configured value.
Minimum time between transmission of Configuration Bridge
Protocol Data Units (BPDUs)
show spanning-tree interface <slot/port>
Privileged EXEC and User EXEC
.
Enabled or disabled
days, hours, minutes, and seconds.
December 2004, 202-10010-02
8-77