Vlan Port Tagging All; No Vlan Port Tagging All; Vlan Protocol Group; Vlan Protocol Group Add Protocol - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Format
Mode

vlan port tagging all

This command configures the tagging behavior for all interfaces in a VLAN to enabled. If tagging
is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as
untagged frames. The ID is a valid VLAN identification number.
Format
Mode

no vlan port tagging all

This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging
is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
Format
Mode

vlan protocol group

This command adds protocol-based VLAN group to the system. The <
characters. When it is created, the protocol group will be assigned a unique number that will be used to identify the
group in subsequent commands.
Format
Mode

vlan protocol group add protocol

This command adds the <protocol> to the protocol-based VLAN identified by <groupid>. A group
may have more than one protocol associated with it. Each interface and protocol combination can
only be associated with one group. If adding a protocol to a group causes any conflicts with
interfaces currently associated with the group, this command will fail and the protocol will not be
added to the group. The possible values for protocol are ip, arp, and ipx.
Default
8-74
no vlan port pvid all <1-4094>
Global Config
vlan port tagging all <1-4094>
Global Config
no vlan port tagging all <1-4094>
Global Config
vlan protocol group <groupname>
Global Config
none
December 2004, 202-10010-02
is a character string of 1 to 16
groupName>
Switching Commands