No Vlan Tagging; Spanning Tree Commands; Show Spanning-Tree - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Format
Mode

no vlan tagging

This command configures the tagging behavior for a specific interface in a VLAN to disabled. If
tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
Format
Mode

Spanning Tree Commands

This section provides detailed explanation of the spanning tree commands. The commands are
divided into two functional groups:
• Show commands display spanning tree settings, statistics, and other information.
• Configuration Commands configure features and options of the switch. For every
configuration command there is a show command that displays the configuration setting.

show spanning-tree

This command displays spanning tree settings for the common and internal spanning tree, when
the optional parameter "brief" is not included in the command. The following details are
displayed.
Format
Mode
Bridge Priority
Bridge Identifier
Time Since Topology Change in seconds
Topology Change Count Number of times changed.
Topology Change
Designated Root
8-76
vlan tagging <1-4094>
Interface Config
no vlan tagging <1-4094>
Interface Config
show spanning-tree [brief]
Privileged EXEC and User EXEC
Configured value.
Boolean value of the Topology Change parameter for the switch
indicating if a topology change is in progress on any port
assigned to the common and internal spanning tree.
December 2004, 202-10010-02
Switching Commands