No Set Garp Timer Join; Set Garp Timer Join All; No Set Garp Timer Join All; Set Garp Timer Leave - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Format
Mode

no set garp timer join

This command sets the GVRP join time per port and per GARP to 20 centiseconds (0.2 seconds).
This command has an effect only when GVRP is enabled.
Format
Mode

set garp timer join all

This command sets the GVRP join time for all ports and per GARP. Join time is the interval
between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering)
membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds)
Default
Format
Mode

no set garp timer join all

This command sets the GVRP join time for all ports and per GARP to 20 centiseconds (0.2
seconds). This command has an effect only when GVRP is enabled.
Format
Mode

set garp timer leave

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service.time is 20 to 600 (centiseconds).
Note: This command has an effect only when GVRP is enabled.
8-44
set garp timer join <10-100>
Interface Config
no set garp timer join
Interface Config
20 centiseconds (0.2 seconds)
set garp timer join all <10-100>
Global Config
no set garp timer join all
Global Config
December 2004, 202-10010-02
Switching Commands