No Snmp-Server Community; Snmp-Server Community Ipaddr; No Snmp-Server Community Ipaddr - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Default
Format
Mode

no snmp-server community

This command removes this community name from the table. The name is the community name to
be deleted.
Format
Mode

snmp-server community ipaddr

This command sets a client IP address for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP mask value to
denote a range of IP addresses from which SNMP clients may use that community to access the
device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with
the mask to determine the range of allowed client IP addresses. The name is the applicable
community name.
Default
Format
Mode

no snmp-server community ipaddr

This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Format
Mode
8-28
Two default community names: Public and Private. You can
replace these default community names with unique identifiers
for each community. The default values for the remaining four
community names are blank.
snmp-server community <name>
Global Config
no snmp-server community <name>
Global Config
0.0.0.0
snmp-server community ipaddr <ipaddr> <name>
Global Config
no snmp-server community ipaddr <name>
Global Config
December 2004, 202-10010-02
Switching Commands