User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Format
Mode
no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is identified by
this <groupid>. The possible values for protocol are ip, arp, and ipx.
Format
Mode
vlan protocol group remove
This command removes the protocol-based VLAN group that is identified by this <groupid>.
Format
Mode
vlan pvid
This command changes the VLAN ID per interface.
Default
Format
Mode
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
Mode
vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to enabled. If
tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Switching Commands
vlan protocol group add protocol <groupid> <protocol>
Global Config
no vlan protocol group add protocol <groupid> <proto-
col>
Global Config
vlan protocol group remove <groupid>
Global Config
1
vlan pvid <1-4094>
Interface Config
no vlan pvid <1-4094>
Interface Config
December 2004, 202-10010-02
8-75