Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
Step 3 Install the smart ETH gateway to the guide rail, as shown in
1.
2.
3.
----End
3.10.2 Installing an Electronic Clasp Lock
Context
● The electronic clasp lock is not required in the 1350 mm deep scenario.
● In the 1600 mm deep scenario, an electronic clasp lock needs to be installed
● The installation position of an electronic clasp lock depends on the positioning
● An electronic clasp lock needs to be installed on the front door of the PDF only
Procedure
Step 1 Install the round lock tongue of the electronic clasp lock.
The electronic clasp lock closes the door by using the cam to trigger the
connecting rod. The cabinet door must be open before the round lock tongue is
installed. Otherwise, the door cannot be opened.
Issue 07 (2022-09-30)
NO TE
The M4 screw used for connecting the ground cable to the cable trough is available in the
cable trough package.
Align the upper slot of the guide rail for the smart ETH gateway with the
upper part of the guide rail, and pre-mount it onto the guide rail.
Press the lower part of the smart ETH gateway to clamp the smart ETH
gateway onto the guide rail.
Shake the smart ETH gateway in different directions to ensure that it is
reliably installed.
NO TICE
respectively on the front and rear doors of each IT device, and on the front
door of each smart cooling product.
plate.
in the cold aisle containment scenario, but cable connection is not required.
NO TICE
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
Figure
3-52.
82
Advertisement
Table of Contents
