Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
5.3.1 Preparations and WebUI Login
Prerequisites
●
●
●
Procedure
Step 1 Connect the PC network port and the WAN1 port (protected by a security
mechanism) on the ECC800-Pro using a network cable.
Table 5-13 Default IP addresses for the WAN and LAN ports on the ECC800-Pro
Port
WAN1
WAN2
LAN1 and LAN2
● In ECC800 V100R002C10 and earlier versions, the default IP address for the
● The WAN1 port IP address cannot be set to an IP address in any of the
● IP addresses for the WAN1 and WAN2 ports should not be set in the same
● In some customized scenarios, the default IP address for the WAN2 port is
● The WAN port supports Internet access, and the LAN port supports LAN access.
Step 2 Configure the PC IP address and the WAN1 IP address in the same network
segment.
If the WAN1 port IP address is 192.168.8.10, subnet mask is 255.255.255.0, and
default gateway is 192.168.8.1, set the PC IP address to 192.168.8.12, subnet mask
to 255.255.255.0, and default gateway to 192.168.8.1.
Step 3 Set LAN parameters.
Issue 07 (2022-09-30)
Supported operating system: Windows 7 and later versions
Recommended screen resolution: 1366 x 768 or higher
Browser: Chrome, Firefox, Internet Explorer 11 or later
NO TICE
WAN1 port is 192.168.1.10.
following network segments: 192.168.0.x, 192.168.245.x, 192.168.246.x and
192.168.248.x.
network segment.
192.168.248.10. The default value may vary.
Connect the PC network port to the WAN port or LAN port on the ECC800-Pro
based on the access network.
Copyright © Huawei Technologies Co., Ltd.
Default IP Address
192.168.8.10
192.168.0.10
192.168.248.10
5 Power-On Commissioning
177
Advertisement
Table of Contents
