Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
4.1 System Cabling Rules
Attaching Cable Labels
Find the corresponding cable based on the wiring diagram in the cable fitting bag,
and attach the corresponding cable label taken out from the cable fitting bag to
both ends of the cable by wrapping the ends.
Attach the cable labels 20 mm away from the plug except for special
circumstances. For example, a label shall not be attached to the bending part of a
cable or attached in some positions that may affect cable installation. If a label
conflicts with a cable tie, attach the label to the outer side of the cable tie.
Attach labels to both ends of a cable.
Requirements for Neatly Routing and Binding Cables
To route and bind cables in an appealing way, follow these rules:
1.
Issue 07 (2022-09-30)
NO TE
The cable labels must completely wrap the cable without wrinkles.
Neatly organize exterior cables in a large bundle of cables and prevent cable
tangles that are avoidable, as shown in
Copyright © Huawei Technologies Co., Ltd.
4
System Cabling
Figure
4-1.
4 System Cabling
119
Advertisement
Table of Contents
