Table of Contents
Advertisement
FusionModule2000-S Smart Modular Data Center
User Manual
Figure 3-110 Connecting the cables
(1) Conversion cable end B, connected to the
water detection cable
Step 3 Connect the other end of the conversion cable to the water detector, as shown in
Figure
Figure 3-111 Connecting the water detector
Step 4 Plan the installation positions for the fasteners of the water detection cable.
Ensure that the water detection cable placed on the fasteners is in good contact
with the floor.
Step 5 Tear off the protection paper on the rear of the fasteners, and then securely attach
the fasteners to the floor.
●
●
Step 6 Drill holes in the floor with the same dimensions as the expansion bolts for the
fasteners. Use the expansion bolts to secure the fasteners to the floor, as shown in
Figure
Issue 07 (2022-09-30)
NO TE
The water detection cable and conversion cable are interconnected through male and
female connectors.
3-111.
If the fasteners cannot be securely attached to the floor, go to
If the fasteners are securely attached to the floor, go to
3-112.
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
(2) Water detection cable end A, connected to
the conversion cable
Step
Step
6.
7.
117
Advertisement
Table of Contents
