Table of Contents
Advertisement
Instrument diagnostics
74
11.7
Service
DIAG
11.7.1 Simulation
Function
Set present
current value at current output 1
Set present
current value at current output 2
Set current relay states
(The number of contacts displayed is
dependent on the instrument expansion level
and configuration)
Measured value simulation
Main measured value
Measured value simulation
Temperature
Note:
In the „Simulation" menu the displayed
value for current output or the
displayed relay state is immediately
displayed. If you change the value in
the window, the current output or the
11.7.2 Internal data
Function
Display instrument number
Display software version of instrument
Display software version of FCL1 module
(CD signal processor) channel 1
Display software version of FCL1 module
channel 2 (for difference)
Display hardware configuration in several
consecutive windows: module, installation
date, slot assignment
Order Code
Reset counter
Mycom CLM 152
→ Service
→ Simulation
→ Internal data
→ Factory settings
→ Instrument check
→ Special functions
Selection
0.00...22.00 mA
0.00...22.00 mA
Select contact by pressing ↑ and ↓.
Open / close selected contact by pressing →.
Free setting across configured measuring
range (sensor independence)
Change current outputs and relay states
depending on their configuration
–35.0 ... +250.0 °C
The current output changes depending on its
configuration
relay state changes at the same
time. If you exit the window, the
simulation is deactivated and the
current outputs and relay states
are reset to the current values.
Selection
No selection
No selection
No selection
No selection
No selection
Alphanumeric entry with characters 0 ... 9 and
a ... Z
0 ... 255 display only
11.7.1
11.7.2
11.7.3
11.7.4
11.7.5
Endress+Hauser
Advertisement
Table of Contents
