Endress+Hauser Mycom CLM 152 Operating Instructions Manual page 77

Mycom CLM 152
11.7.3 Factory settings
Function
Factory settings
(instrument reset)
set config
Only reset setting data
Reset only calibration data
Reset all data
Caution:
If the calibration data are reset, you
must carry out a recalibration of the
measuring system.
11.7.4 Instrument check
Function
Test type
Keypad
Display
RAM
EPROM
EEPROM
Endress+Hauser
Abort
set config (accept changed slot assignment),
setting data only,
calibration data only,
all data,
(Service data, logbook, reset counter, message log
⇒ only for authorised service personnel, only with service code)
After pressing E the hardware equipment is checked and
a changed slot assignment accepted.
After pressing E to reset all setting data for instrument
configuration to factory settings.
Caution:
All previous data for instrument configuration
are lost!
After pressing E to reset all setting data for instrument
configuration to factory settings.
Caution:
All previous calibration data are
lost!
After pressing E, configuration and calibration data are reset
to factory settings.
Caution:
All previous data for configuration and
calibration are lost!
Selection: keypad, LCD, RAM, EPROM, EEPROM
Graphical display of keypad.
Press all keys in succession. If the key function is in order,
a message appears in the LCD.
Press E to return to the Test type selection menu.
A chessboard pattern is displayed in normal and inverse video.
Check the display for missing pixels. Press E to return to the
"Test type selection menu".
Self-test. On expiry of test time, the result is displayed.
Press E to return to the "Test type selection menu".
Selection
Description
Instrument diagnostics
lm152e11.chp
75