Configuring The Totalizer - Endress+Hauser Proline Teqwave MW 300 Operating Instructions Manual

Commissioning
Parameter
Assign process variable 1
Process variable unit 1
Totalizer 1 operation mode
Totalizer 1 failure behavior
* Visibility depends on order options or device settings
102
10.6.2

Configuring the totalizer

The totalizer is used to calculate the total load rate. The Load rate option is only
available if the volume flow of the medium is read in via the Current input 1 to n.
In the "Totalizer 1 to n" submenu, you can configure the totalizer.
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to n
‣
Totalizer 1
Assign process variable 1
Process variable unit 1
Totalizer 1 operation mode
Totalizer 1 failure behavior
Parameter overview with brief description
Prerequisite
The Load rate option is only
available if the volume flow of
the medium is read in via the
Current input 1 to n or the
fieldbus.
A process variable is selected
in the Assign process variable
parameter (→  102) of the
Totalizer 1 to n submenu.
A process variable is selected
in the Assign process variable
parameter (→  102) of the
Totalizer 1 to n submenu.
A process variable is selected
in the Assign process variable
parameter (→  102) of the
Totalizer 1 to n submenu.
Description
Select process variable for
totalizer.
Select the unit for the process
variable of the totalizer.
Select totalizer operation
mode, e.g. only totalize
forward flow or only totalize
reverse flow.
Select totalizer behavior in the
event of a device alarm.
Proline Teqwave MW 300 HART
→  102
→  102
→  102
→  102
Selection Factory setting
• Off Off
*
• Load rate
Unit choose list Depends on country
• Net Net
• Forward
• Reverse
• Hold Hold
• Continue
• Last valid value +
continue
Endress+Hauser