Table of Contents
Advertisement
The Web Server Interface features four (4) navigation tabs at the top of each page. Nested
hyperlinks (shown in gray) grant access to individual Web pages. The hyperlink for the
Redundancy page is available under the Config tab.
Home
Contact
Support
Click the Config tab, and then select the Redundancy hyperlink to continue.
B.2.2 Config | Redundancy Page
Use this page to configure the HPOD 1:1 or 1:2 redundancy operations settings.
Figure B-2. SSPA Web Server Interface – 'Config | Redundancy' Page
At any time, click [Refresh] to update this page and see the most recent data.
Redundancy State and Mode
Use the drop-down list to set the Redundancy State as Off, 1:1, or 1:2.
Use the drop-down list to set the Redundancy Mode as Manual or Automatic.
Click [Change] to save these settings.
Appendix B
HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Access
Amplifier
SNMP
Utility
Redundancy
B–5
Revision 9
Monitor
Alarms
FETs
MN/HPOD.IOM
Advertisement
Table of Contents
