Comtech EF Data HPOD Installation And Operation Manual page 49

3) Use Telnet Remote Control or the HPOD Web Server Interface to verify that the PC-
to-Unit FTP file transfer was successful.

Via Telnet Remote Control – Type the "<1/FRW?" remote query (without quotes) at
the command prompt. The unit will return the Bulk, MnC, and FPGA firmware load
information.

Via the HPOD Web Server Interface – Open the 'Config | Utility' page and review the
SC/13320 Board Firmware Version section to verify that the PC-to-Unit FTP file transfer
was successful.
4) Use the HPOD Web Server Interface to select the boot image. To select the desired boot
Image, open the HPOD Web Server Interface 'Config | Utility' page. Use the Next Reboot
Image drop-down list in the Current SC/13320 Active Firmware Image # section to select 1
or 2, and then click [Submit].
5) Reboot the HPOD.
A. Disconnect the power source from the HPOD.
B. Re-energize the HPOD. The unit will reboot using the updated firmware image.
6) To update the other firmware image, repeat steps 1 through 5.
The HPOD is now operating with its latest firmware. The Ethernet-based firmware update
process is now complete.
Updating Firmware
HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
3–12
Revision 9
MN/HPOD.IOM