Table of Contents
Advertisement
Command
Parameter
Number of
(Instruction
Type
Arguments
& Qualifier)
Concise
N/A
84 bytes,
Maintenance
alphanumeri
Status
c
Configure
CRA=
1 byte
Redundancy
value of 0,1
Amp
Concise
N/A
11 bytes,
Utility Status
alphanumeri
c
Serial-Based Remote Product Management
Description of Arguments
Query only.
Reports the concise version of RMS. The response is comma
delimited in the form aaa.a,bbb.b,ccc.c,ddd.d,eee.e,
fff.f,ggg.g,hhh.h,iii.i,jjj.j,kkk.k,lll.l,mmm.m,nnn.n,'cr''lf' where:
aaa.a = +24V Power Supply
bbb.b = +15V Power Supply
ccc.c = +10V-1 Power Supply
ddd.d = +10V-2 Power Supply
eee.e = +7.5V Power Supply
fff.f = +5V Power Supply
ggg.g = -5V Power Supply
hhh.h = Fan #1 speed (in percent)
iii.i = Fan #2 speed (in percent)
jjj.j = Amplifier temperature in deg. C
kkk.k = Amplifier 10V1
lll.l = Amplifier 10V2
mmm.m=Forward RF output power, in dBm
Note: nnn.n will appear for Ref Voltage if Reference Oscillator
Module is installed.
Command or query.
Permits configuration of the redundancy amplifier mode in 1:1
and 1:2 redundancy systems, in the form x, where:
0 = Disabled - the offline unit's amp state will follow the online
unit's amp state (Default).
1 = Enabled - the offline unit's amp state will be Off, if it becomes
the online unit, then its amp state will be On. This affects all units
in the redundancy system.
Note: The same CRA value should be sent to all units in the
redundancy system.
Query only.
Reports the Maintenance status of the unit. Response is comma
delimited in the form aaaa,bbbb,ccc,'cr''lf' where:
aaaa = Remote Unit Address
bbbb = Remote Baud Rate
5–15
HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier
Query
Response to
(Instruction &
Command
Qualifier)
N/A
CMS?
CRA=
CRA?
CRA?
N/A
CUS?
Revision 9
Response to
Query
CMS=x....x
(See
Description of
Arguments)
CRA=x
(See
Description of
Arguments)
CUS=x....x
(See
Description of
Arguments)
MN/HPOD.IOM
Advertisement
Table of Contents
