Sensors & Software CONQUEST 100 User Manual page 56

Conquest 100 Tools & Setup
Figure 5-9: Red arrow pointing to the button to put into pairing mode
Press Scan to re-scan for devices. Once it locates that device, it will indicate that it's paired
(Figure 5-10). The device will exit pairing mode if you don't pair to it within about 30 seconds.
You will need to put it into pairing mode again and re-try.
Figure 5-10: Paired to a device
Use the 4-way directional arrows or touchscreen to select that device, then press Connect
(Figure 5-11).
46