Table of Contents
Advertisement
Conquest 100
Main Screen
4
Main Screen
The first time you turn on Conquest 100, you will need to configure the system (Figure 4-1). A
series of screen prompts will allow you to setup the language, units, date & time, and some
other options. A reboot is required once this is complete. This will have to be done anytime the
embedded software is updated (13.6).
Figure 4-1: Initial configuration screen
Every subsequent time the system boots up, you will see the main screen (Figure 4-2). If you
have purchased (or upgraded to) the Conquest 100 Enhanced, you will see the screen in Figure
4-3.
33
Advertisement
Table of Contents
Need help?
Do you have a question about the CONQUEST 100 and is the answer not in the manual?
Questions and answers