E-Mail - Sensors & Software CONQUEST 100 User Manual

Conquest 100
•
Green = Connected
•
Yellow = Not currently connected, but remembered from before when you previously
connected and entered a password.
•
White = Not connected
The buttons at the bottom of the screen perform the functions described below:
o Connect – Select the desired network and press Connect. If the connection is successful
(this can take a minute or so) a screen appears asking for the password for that network. If
the network name is yellow (from a previous connection to this network), it will not ask for a
password because it is a remembered network. Once it connects the Network Name will turn
green.
o Forget – Use the Forget button to remove the password for connected or remembered
networks (text in green or yellow). Once the 'forget' button is pressed on a selected network
it will remove the password and the Network Name will turn white. You will also be
disconnected if you are currently connected to that network.
o Scan – Scans for any available networks in the area and displays them in order of strength
of signal. You may need to press this button a second time if you don't see the network you
are looking for.
o Details – Pressing this button displays the security settings and device addresses related to
the selected network.
o Back – Press this button to return to the Preferences screen.

5.1.7 E-mail

Press the button on the right (which may have an existing e-mail address or say None) to arrive
at a sub-menu where you can setup and configure a sending e-mail address. Ensure that this
e-mail address already exists. This is the sending account where messages will originate from.
All mini-reports received by the recipient will appear to come from this account.
NOTE: you must be connected to a wireless network before you setup an E-mail address.
Using GMAIL
The system is already pre-configured to use GMAIL as the e-mail provider for the sending
account (Figure 5-5)
40
Tools & Setup