Sensors & Software CONQUEST 100 User Manual page 51

Table of Contents

Conquest 100

•

Press Username to display a keyboard where you can enter your GMAIL user name

only; you do not need to enter @gmail.com. Then press OK when done (Figure 5-6)

•

Press Password to display a keyboard where you can enter your GMAIL password.

Then press OK when done (Figure 5-6).

•

Press Save when both Username and Password have been entered.

If there are no warning messages, the e-mail address is setup properly and you are ready to e-

mail mini-reports from the field. If this does not work, see the

Using Another Provider

Note: It is highly recommended to use a GMAIL account as the system is pre-configured

for this. If you choose to use another provider, you will have to contact that provider if

you have any issues with the settings.

Figure 5-5: Using Gmail as e-mail provider

Figure 5-6: Entering e-mail address and password

Tools & Setup

Failed Setup

section below.

Table of Contents

Need help?

Do you have a question about the CONQUEST 100 and is the answer not in the manual?