Advertisement
• Select the setting item to enter a setting sub-menu and press the ENTER key.
In view mode, the input column of each setting sub-menu and the cursor are not displayed.
CAUTION
Modification of settings :
"scheme switch" and "protection element" in the "Protection" menu. Dependencies exist between
the settings in the various menus, with settings in one menu becoming active (or inactive)
depending on the selection made in another menu. Therefore, it is recommended that all necessary
setting changes be made while the circuit breaker tripping circuit is disconnected.
Alternatively, if it is necessary to make setting changes with the tripping circuit active, then it is
recommended to enter the new settings into a different settings group, and then change the "active
group" setting, thus ensuring that all new settings become valid simultaneously.
4.2.6.1 Setting Method
There are two setting methods as follows:
- To enter into a selected item
- To select numerical values
To enter into a selected item
If a screen as shown below is displayed, perform settings as follows.
The cursor (underbar) can be moved to upper or lower lines within the screen by pressing the
and
keys. If setting change is not required, skip the line with the
S e t t i n g s m e n u
P r o t e c t i o n
C o n t r o l
R e c o r d
S t a t u s
T i m e
C o m m u n i c a t i o n
P a s s w o r d
P a n e l
O t h e r s
• Move the cursor to a setting item.
• Press the ENTER key.
To select letter settings
If a screen as shown below is displayed, perform settings as follows.
The cursor can be moved to upper or lower lines within the screen by pressing the
If setting change is not required, skip the line with the
S e t t i n g s - P r o t e c t i o n
Care should be taken when modifying settings for "active group",
2 5 / F e b / 2 0 0 3 0 9 : 4 5
2 5 / F e b / 2 0 0 3 0 9 : 4 5
⎯
⎯
170
and
keys.
and
keys.
6 F 2 S 0 8 4 2
and
key.
Advertisement
