Precautions For Correct Use; Installation Site; Connecting Cable; Optical Axis Of The Camera - Omron FJ Series Camera Setup Manual

Precautions for Correct Use

In order to prevent the product from becoming inoperable or malfunction, and to prevent other adverse
effects to the performance or equipment, please observe the following.

Installation Site

Do not install the product in locations subjected to the following conditions:
• Ambient temperature outside the rating
• Rapid temperature fluctuations (causing condensation)
• Relative humidity outside the range of 35 to 85%
• Presence of corrosive or flammable gases
• Presence of dust, salt, or metallic particles
• A location not exposed to direct vibration or impact.
• Reflection of intense light (such as other laser beams or electric arc-welding machines)
• A location not near a heating appliance or exposed to direct sunlight.
• Water, oil, or chemical fumes or spray
• A location not exposed to strong magnetic/electric fields.
• A location not near a high-voltage device or power device.

Connecting Cable

• Be sure to turn off the power before disconnecting the cables.
• To attach the camera cable (LAN) FJ-VSG (optional), tighten the fixing screws with the recommend-
ed torque (0.15N·m). Excessive force on the camera connector may cause malfunction.
• For information on specifications of Camera cable (power supply, I/O) FJ-VSP (sold separately), see
the pin assignment table described later. Excessive force on the camera connector may cause mal-
function.
• When not using the Camera cable (power supply, I/O) FJ-VSP (sold separately), perform wiring so
as not to be affected by other wiring or devices.
• For information on specifications of Camera cable (power supply, I/O) FJ-VSP2 (sold separately),
see the pin assignment table described later.
• When not using the Camera cable (power supply, I/O) FJ-VSP2 (sold separately), perform wiring so
as not to be affected by other wiring or devices.
• Attach the accessory ferrite cores to both ends of the camera cable (power and I/O) FJ-VSP2 (op-
tional).
• Do not use camera cables longer than the specified length.

Optical axis of the Camera

• The optical axis may vary product by product. Therefore, when installing the Camera, always check
the center of the image displayed on the monitor. The optical axis of this product may vary over a
couple of pixels due to the variation of ambient temperature because of the material characteristics.
FJ Series (Camera & Software Vision Package) PC Vision System Camera Setup Guide (Z428-E1)
Precautions for Correct Use
11