Table of Contents
Advertisement
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
40000019-00000000
LAN: Ethernet[[arg1]] interface
is now active.
Explanation: This message is for the use case where
a Management Controller ethernet interface is now
active.
Internal Event: No
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0025
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
4000001a-00000000
DHCP setting changed to
[arg1] by user [arg2].
Explanation: This message is for the use case where
a user changes the DHCP setting.
Internal Event: No
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0026
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
4000001b-00000000
Management Controller [arg1]:
Configuration restored from a file by
user [arg2].
Explanation: This message is for the use case where
a user restores a Management Controller configuration
from a file.
Internal Event: No
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0027
40000019-00000000 • 4000001d-00000000
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
4000001c-00000000
Watchdog [arg1] Screen
Capture Occurred .
Explanation: This message is for the use case where
an operating system error has occurred and the screen
was captured.
Internal Event: No
Severity: Info
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0028
SNMP Trap ID: 22
Automatically notify Support: No
User response: If there was no operating-system
error, complete the following steps until the problem is
solved:
1.
Reconfigure the watchdog timer to a higher value.
2.
Make sure that the IMM Ethernet-over-USB
interface is enabled.
3.
Reinstall the RNDIS or cdc_ether device driver for
the operating system.
4.
Disable the watchdog.
If there was an operating-system error, check the
integrity of the installed operating system.
4000001d-00000000
Watchdog [arg1] Failed to
Capture Screen.
Explanation: This message is for the use case where
an operating system error has occurred and the screen
capture failed.
Internal Event: No
Severity: Error
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0029
SNMP Trap ID: 22
Automatically notify Support: No
User response: Complete the following steps until the
problem is solved:
1.
Reconfigure the watchdog timer to a higher value.
2.
Make sure that the IMM Ethernet over USB
interface is enabled.
35
Chapter 3. Diagnostics
Advertisement
Table of Contents
