Table of Contents
Advertisement
Power supply
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the chassis that contains the power supply is installed in an iDataPlex with the
3. Remove the power cord if there is any attached to the power supply (see
4. Carefully pull the power supply out of the chassis.
5. If you are instructed to return the power supply, follow all packaging instructions,
Installing a power supply in a 2U chassis
Notes:
1. If you are installing a 900 watt redundant power supply unit, make sure the
2. Both plugs of 900 watt redundant power supply should be plugged in to PDU or
Table 14 shows the power supply configuration.
2U chassis
Release latch
on page 275.
rail having the power cord retention feature, remove it off from the rack (see
"Removing the 2U chassis from a rack" on page 284).
"Removing the power cord from the rail without power cord mounting bracket"
on page 298).
and use any packaging materials for shipping that are supplied to you.
input power is phase-to-phase, or, phase-to-neutral, 200 volt to 240 volt
nominal, AC, 47-63 Hz.
outlet together.
Table 14. Power supply configuration
Microprocessor
750 W fixed
SKU
module
130 W with more
Not available
than 8 DIMMs
130 W with less
Not available
than or equal to
8 DIMMs
750 W
900 W fixed
redundant
module
module
x2
Not available
x1
Not available
Chapter 5. Removing and replacing server components
900 W
redundant
module
Not available
x2
317
Advertisement
Table of Contents
