Table of Contents
Advertisement
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 275.
2. Touch the static-protective package that contains the drive to any unpainted
metal surface on the outside of the chassis or rack; then, remove the hard disk
drive from the package.
Attention:
Do not press on the top of the drive. Pressing the top might
damage the drive.
3. Align the drive with the guide rails in the drive bay.
4. Slide the retention tab; then, carefully slide the drive into the bay until it stops,
and release the retention tab.
5. Install the filler panel in the drive bay.
6. Turn on the system-board tray (see "Turning on the node" on page 10).
Chapter 5. Removing and replacing server components
295
Advertisement
Table of Contents
