Table of Contents
Advertisement
10. Fasten the captive screws on the network adapter.
11. Fasten the thumbscrew on the front of the chassis.
12. Reinstall the PCI riser-card assembly in PCI riser connector 2 if you have
13. Install the system-board tray cover (see "Installing the system-board tray
14. Install the system-board tray in the chassis (see "Installing the system-board
Removing a GPGPU enclosure
To remove a GPGPU enclosure, complete the following steps.
3.5-inch
filler panel
1. Read the safety information that begins on page vii and "Installation guidelines"
4. If a GPGPU enclosure is installed on the system-board tray, remove it (see
"Removing a GPGPU enclosure" on page 281); otherwise, remove the
system-board tray cover (see "Removing the system-board tray cover" on page
280).
5. Remove the PCI riser-card assembly (if installed) from PCI riser connector 2
(see "Removing a PCIe riser-card assembly from the system-board tray" on
page 302).
6. Remove the adapter filler panel on the front of the chassis (if it has not been
removed already).
7. Touch the static-protective package that contains the new adapter to any
unpainted metal surface on the server. Then, remove the adapter from the
package.
8. Align the adapter so that the port connectors on the adapter line up with the
pin and thumbscrew on the chassis; then, tilt and slide the adapter so the port
connectors on the adapter and the network adapter connector on the planar
are aligned.
9. Press the adapter firmly until the pin, and retention brackets engage the
adapter. Make sure the adapter is securely seated on the connector on the
planar.
Attention:
Make sure the port connectors on the adapter are aligned
properly with the chassis on the rear of the server. An incorrectly seated
adapter might cause damage to the system board or the adapter.
removed it previously (see "Installing a PCI riser-card assembly on the
system-board tray" on page 303).
cover" on page 280).
tray in a 2U chassis" on page 279).
3.5-inch
simple-swap
hard disk drive
on page 275.
3.5-inch
simple-swap
backplate
Retention pin
Chapter 5. Removing and replacing server components
GPGPU enclosure
Retention bracket
Adapter
323
Advertisement
Table of Contents
