IBM System x iDataPlex dx360 M4 7912 Service Manual page 320

Installing a power-supply paddle card in the tray
To install a power-supply paddle card in the tray, complete the following steps.
System-board tray
1. Touch the static-protective package that contains the power-supply paddle card
2. Place the power-supply paddle card on the mounting studs in the tray and
3. Reconnect the power-supply paddle card cables.
4. Install the simple-swap drives, if you removed any. Complete the following
5. Install the system-board tray cover (see "Installing the system-board tray cover"
6. Install the system-board tray in the chassis (see "Installing the system-board
Removing a PCIe riser-card assembly from the system-board tray
Note: PCI riser-card brackets must be installed even if you do not install an
adapter.
To remove a PCI riser-card assembly from the system-board tray, complete the
following steps:
302
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
Power-supply
paddle card
to any unpainted metal surface on the outside of the tray; then, remove the
power-supply paddle card from the package.
install the four screws.
steps:
a. Install the hard disk drive bracket and cable assembly.
b. Reconnect the hard disk drive bracket and cable assembly cables.
c. Install the hard disk drive (see "Installing a simple-swap hard disk drive" on
page 294).
on page 280).
tray in a 2U chassis" on page 279).