GE Voluson E Series Service Manual page 91

3.7.1.13.1 Disk Encryption Workflow
1. Invoke System Setup as described in
2. On the right side of the screen select
3. Start Encryption.
a. Set unlock password and Retype password .
Note The entered password is not visible and has a minimum of 8 characters.
b. Click
Identifier and Recovery key as well as an USB unlock key is automatically created by the system.
Save recovery key to an external or network device.
c.
d. Choose connected printer from the pull down-menu and click
e. If desired, click the
f. Click the
Note The process of enabling encryption of the patient data will take a considerable amount of time (one to
several hours).
g. Confirm the dialogs with
A progress bar is displayed during disk encryption process.
The system should not be used while encryption process in ongoing.
Note
3.7.1.13.2 Unlock an encrypted Disk
If patient data stored on the internal HDDs D:\ partition are encrypted (protected), following dialog window
appears as soon as the system is started.
Voluson E-Series Service Manual
5539550APB Revision 6
Section 3.7.1.1 on page 3-43
Administration and then click the Disk Encryption tab.
Figure 3-37 System Setup - Administration - Disk Encryption
Create unlock keys .
Save to USB button to save the USB unlock key to a connected USB device.
Start encryption button.
Yes and OK to start encryption.
Figure 3-38 unlock screen at encrypted disk
Setup Instructions
.
Print recovery key .
3-47