Remote Control Selection - GE Voluson E Series Service Manual

3.6.6 Remote Control Selection

To assign an auxiliary device (e.g., printer) to the remote keys P1, P2, P3, P4, P5 and/or P6:
1. Press the Utilities key on the control console.
2. In the "Utilities" menu touch the
3. On the right side of the screen select
1 Overview
1a Configure buttons
1b Select Printer
1c Recorder Control
1d Select P? key to send Email
1. Overview tab:
a. Configure "Remote" Buttons: Select the desired remote control button.
b. Select Printer: Check mark and select the desired Printer for the remote control button.
c. Recorder Control: Check mark this item to use the selected P? key for Recorder Control.
d. Check mark "Use P? key to send Email", and adjust
Optionally the Printer Remote Control can be done by the Foot switch; see
Note
2. Detailed Setup tab:
a. If it is desired, check mark "Use Report Printer for Reports"
3.6.6.1 Report Printer Selection
1. Click on the
2. Select the desired Report Printer from the pull-down menu.
The selected Report Printer is usually used for printing reports and images from the Archive.
Note
Voluson E-Series Service Manual
5539550APB Revision 6
Setup button to invoke the setup desktop on the screen.
Connectivity and then click the Button Configuration tab.
Figure 3-34 Setup - Connectivity - BUTTON CONFIGURATION page (Overview)
Peripherals tab; see Figure 3-28 on page 3-37
Setup Instructions
2 Detailed Setup
Settings .
Figure 3-28 on page 3-37
.
.
3-41