How To Use The Auto Tester Program - GE Voluson E Series Service Manual

Diagnostics/Troubleshooting

7.7 How to use the Auto Tester program

1. Press the Utilities key on the control console.
2. In the "Utilities" menu touch the
3. On the right side of the screen select
4. Enter the password « she » and click the
5-27 on page 5-50
5. Activate the "Auto Tester" program by clicking
OK .
6. Click
7. Press the Alt Gr key on the alphanumeric keyboard.
8. Activate the "Auto Tester" program by clicking the
9. Start scanning. You can scan normally and everything will be recorded to the program (up to several
hours).
It is important that you are recording the processes where the errors normally occur.
Note
7-18
Setup button to invoke the setup desktop on the screen.
Administration and then click the Service tab.
Accept button to display the Service Tools page (see
).
Figure 7-23 Autotester activation
Figure 7-24 Autotester record
Stop the program by clicking on [Stop] shown on the screen, or by pressing the Alt Gr key
on the alphanumeric keyboard.
Start . The following message box appears.
"Record" icon on the displayed screen.
Figure
Voluson E-Series Service Manual
5539550APB Revision 6