Setup Instructions
3.5.8 Connecting the Wireless Network Adapter
1.
Turn ON the power of the system and wait till the system has booted.
2.
Plug the Wireless Network adapter into an accessible USB port of the Voluson E-Series. All software
drivers are pre-installed for the designated Wireless Network adapter only.
The Wireless Network Adapter can be connected to any accessible USB port.
Connection is always the same (no differences between PC-Motherboard version of the Voluson E-Series
Note
system).
After physical connection of the WLAN adapter to the Voluson E-Series system, follow the procedure
Note
described in
Section 3.13.2 "Wireless Network Configuration" on page 3-59
3-28
Figure 3-21 Connection Scheme - Wireless (USB) Network Adapter
.
Voluson E-Series Service Manual
5539550APB Revision 6