Table of Contents
Advertisement
Polycom ATX Integrator's Guide
Installing the Ceiling Microphone Arrays
3 - 4
Before you begin, check the height of the ceiling in the ATX room. If the ceiling
is 10' (304.8 cm) or higher, you will need an optional 6' (182.2 cm) drop cable
for each Ceiling Microphone Array. To ensure that you are using the correct
cable, verify that the number of pins on the cable connector matches the
number of pins on the connector on the electronics enclosure.
To install the Ceiling Microphone Arrays:
Determine where you will place the Ceiling Microphone Arrays in the
1
room:
— For the ATX 200 system:
»
The center Ceiling Microphone Array must be centered on the
table, between seats 2 and 3.
»
The left Ceiling Microphone Array must be centered between
seats 1 and 2.
»
The right Ceiling Microphone Array must be centered between
seats 3 and 4.
»
The distance from the front edge of the table to the Ceiling
Microphone Arrays is 3' (91 cm).
»
The height of the Ceiling Microphone Arrays from the floor must
be between 6'8" (203 cm) and 7' (213 cm).
3'
B
1
Figure 3-2
LEFT MIC
CENTER MIC
A
A
D
C
B
D
2
53"
6-12"
ATX 200 Ceiling Microphone Array Placement
RIGHT MIC
A
C
B
D
C
3
4
53"
Polycom, Inc.
Advertisement
Table of Contents
