Installing The Crestron Touch Panel; Attaching The Serial Number Label; Connecting The Cables - Polycom ATX 200 Integrator Manual

Installing the Crestron Touch Panel

Attaching the Serial Number Label

Connecting the Cables

Polycom, Inc.
To install the Crestron Touch Panel:
Place the Touch Panel on the table.
1
For wired panels using the TPS-IMPC interface module, place the
2
TPS-IMPC module in a location where the cable from the Touch Panel
can easily reach it.
Connect one end of the Touch Panel cable to TPS-IMPC and connect the
3
other end to the back of the Touch Panel.
Be sure to leave enough slack on the Touch Panel side of the cable so that
users can easily move the Touch Panel to a comfortable position on the
table.
A serial number label is supplied with each ATX system.
The ATX Warranty and Service Maintenance Agreement is determined by this
unique serial number, which applies to the complete list of Polycom
components shipped with the ATX system. This single serial number also
enables Support to keep track of issues related to the particular ATX system.
Therefore, all of the Polycom components shipped with the ATX system must
remain together. Do not swap out individual components, such as one codec
or one camera, without authorization. In addition, the integrator should keep
track of this serial number for the customer.
When you attach the serial number label, it is important to adhere it where it will be
easily accessible and will not get discarded. Polycom suggests that you adhere the
label to equipment that will permanently reside with the ATX system, such as the
electronics rack. Do not adhere the label to an individual component, such as a
codec, because if that component needs to be replaced, the label may be lost.
At this point in the installation, connect the cables to the ATX components
according to your own wiring configuration. Polycom provides the Polycom
ATX 200/300/400 System Wiring Specification (part number 3823-30099-002)
with each ATX system as a sample configuration.
The sample configuration in the Polycom ATX 200/300/400 System Wiring
Specification shows a serial interface between the System Controller and all three
codecs. However, for an ATX SDK version
between the Primary (Master) codec and the System Controller.
Installing the Remaining Electronic Components
3.0.3
, you only need a serial interface
3 - 15