Performing The Remaining Software Configuration; Itp Features - Polycom ATX 200 Integrator Manual

Polycom ATX Integrator's Guide

Performing the Remaining Software Configuration

Configuring the System Controller, Telepresence Tool, and ITP Features
4 - 6
Enter the option key:
7
When the codec has finished rebooting, go to Admin Settings >
a
General Settings > Options in the web UI.
Enter the option key code in the Key field.
b
The option key enables the options that are required for Immersive
Telepresence.
Click Update.
c
Repeat steps 6 and
8
Go to Admin Settings > General Settings > Security > Security Settings.
9
10 If the Enable Sessions List check box appears on the screen, clear the
check mark from the check box.
11 Click Update.
12 Repeat steps 9 through
This section describes the tasks you need to perform to complete the software
configuration.
Refer to the Polycom Immersive Telepresence (ITP) Administrator's Guide (part
number 3725-26945-005) to:
• Configure the HDX codecs and the System Controller (Chapter 1)
Because you have already installed the Polycom HDX software, you can
skip the "Upgrading the Polycom HDX Software" section in Chapter 1 of
the Administrator's Guide and begin instead with the "Configuring the
System Controller" section.
• Load the Polycom Touch Control (for the ATX 300 system only) or the
Crestron Touch Panel software (Chapter 2)
Note that the ATX SDK does not support the Polycom Touch Control.
• For the ATX 300 system only, configure the system parameters with the
System_Config.ini file (Chapter 3)
Note that the ATX SDK does not use the System_Config.ini file.
• Install and use the Telepresence Tool (Chapter 4)
• Pair the Polycom Touch Control with the HDX codec and the System
Controller (for sites with a Polycom Touch Control) (Chapter 5)
7 for the remaining codecs.
11 for the remaining codecs.
Polycom, Inc.