Setting Preset 95 - Polycom ATX 200 Integrator Manual

Blue lines

Setting Preset 95

Blue lines
Polycom, Inc.
Adjust the tilt so that the top edge of the table aligns with the blue line
b
at the center of all screens as shown in
Figure 5-20 Aligning the Cameras for Preset 96 — ATX 300 System
After all the cameras are aligned, make sure Preset 96 is selected and then
3
press Set to save Preset 96 for all the codecs.
This section describes how to align the cameras for Preset 95 in an ATX 400
room.
To set Preset 95 for an ATX 400 system:
On the Telepresence Tool Camera Alignment tab, select Preset 95.
1
Use the camera controls to adjust the pan, tilt, and zoom of Camera-1 (B1)
2
and Camera-2 (B2):
Pan, tilt, and zoom Camera-1 (B1) to view seats 1, 2, 3, and 4.
a
Pan, tilt, and zoom Camera-2 (B2) to view seats 5, 6, 7, and 8.
b
Adjust the tilt so that the top edge of the table aligns with the blue line
c
at the center of both screens as shown in
(Black Video)
Figure 5-21 Aligning the Cameras for Preset 95 — ATX 400 System
Configuring the Displays, Cameras, and Audio
Figure 5-20.
Figure 5-21.
(Black Video)
5 - 23