Setting Preset 97; Figure 5-12 Aligning The Cameras For Preset 99 - Atx 400 System; Figure 5-13 Aligning The Cameras For Preset 97 - Atx 200 System - Polycom ATX 200 Integrator Manual

Polycom ATX Integrator's Guide
Yellow lines

Setting Preset 97

5 - 18
Figure 5-12 Aligning the Cameras for Preset 99 — ATX 400 System
If the table edge in any display does not align with the yellow lines,
c
physically adjust the corresponding camera using shims.
After all the cameras are aligned, make sure Preset 99 is selected and then
3
press Set to save Preset 99 for all the codecs.
This section describes how to align the cameras for Preset 97 in an ATX 200,
ATX 300, and ATX 400 room.
Setting Preset 97 for an ATX 200 System
To set Preset 97 for an ATX 200 system:
On the Telepresence Tool Camera Alignment tab, select Preset 97.
1
Use the camera controls to adjust the pan, tilt, and zoom of the camera
2
connected to the Primary codec:
Pan, tilt, and zoom the camera to view the four seats.
a
Adjust the pan and zoom so that the two camera alignment marks on
b
the outside of the table are as close as possible to the edges of the
displayed video.
Adjust the tilt so that the edge of the table aligns with the blue line as
c
shown in Figure
Blue line
Figure 5-13 Aligning the Cameras for Preset 97 — ATX 200 System
5-15.
(Black Video)
Polycom, Inc.