Installing The Displays And Table; Installing The Cameras - Polycom ATX 200 Integrator Manual

Installing the Displays and Table

Installing the Cameras

Polycom, Inc.
Once you have determined where to place the displays, you can install them
on the wall. After installing the displays, place the rear edge of the table 110"
(279.4 cm) from the front of the displays. The table should be parallel to the
displays and the centerline of the table should align with the centerline of the
displays as shown in Figure
Left Display
171" [4.34 m] minimum
Figure 2-6 Placing the Table Relative to the Displays — ATX 300 System
Both the ATX SDK and ATX 300 solutions come equipped with Polycom
EagleEye III cameras. When installing the cameras, you must center one
camera above each display.
You can either attach the cameras to the wall above the displays or you can
install the cameras on top of the displays. Polycom highly recommends
attaching the cameras to the wall. By doing so, the cameras are less likely to
become misaligned if the displays get bumped. If you choose to install the
cameras on top of the displays, carefully secure the cameras and mounts so
that the camera alignment is maintained.
Whether you are planning to install the cameras on the wall or on top of the
displays, you must first attach them to the Polycom EagleEye shelf. For
information about how to attach the cameras to the shelf and how to mount
Installing the Displays, Table, Cameras, and Chairs
2-6.
Center Display
110" [2.79 m]
Displays and Table
Centerline
Right Display
2 - 9