Figure 5-17 Aligning The Cameras For Preset 97 - Atx 400 System; Figure 5-18 Camera Control Screen - Polycom ATX 200 Integrator Manual

Blue line
Polycom, Inc.
Adjust the tilt so that the edge of the table aligns with the blue line as
c
shown in Figure
(Black Video) (Black Video)
Figure 5-17 Aligning the Cameras for Preset 97 — ATX 400 System
Do not pan, tilt, or zoom the other cameras at this point.
3
Open the camera controls for the camera attached to codec 2 and select 2
4
from the Select Camera drop-down list. This will result in the codec
sending black video.
Open the camera controls for the camera attached to codec 3 and select 2
5
from the Select Camera drop-down list. This will result in the codec
sending black video.
Open the camera controls for the camera attached to codec 4 and select 2
6
from the Select Camera drop-down list. This will result in the codec
sending black video.
Make sure Preset 97 is selected and then press Set to save Preset 97 for all
7
the codecs.
Configuring the Displays, Cameras, and Audio
5-15.
Figure 5-18 Camera Control Screen
(Black Video)
5 - 21