Table of Contents
Advertisement
Polycom, Inc.
Click Set DVI Mon.
7
The output settings will change and the setup wizard will appear on the
ATX displays. (In order for the wizard to appear on the displays, the
displays must be able to handle 1024 x 768 display resolution.)
Complete the setup wizard:
8
Select American English.
a
Select the country where the system will be installed (United States is
b
the default).
For the System Name, as an example for an ATX 300 room, enter
c
HDX1, HDX2, or HDX3. Alternatively, you can enter more specific
names if requested by the customer.
For the LAN Properties, select the following:
d
»
IP Address: Specify or Automatic (should be determined by the
customer's system administrator).
Polycom recommends selecting Specify and then entering the IP
address and the LAN settings at this point in the installation.
To insert the periods into the IP address, press the right arrow
button on the HDX Soft Remote.
Figure 4-2
»
Connect to LAN: Yes
»
Allow IP calls: Yes
»
Enable EAP/802.1X: Leave the check box unchecked.
»
Enable 802.1p/Q: Leave the check box unchecked.
»
Enable PC LAN Port: Leave the check box unchecked.
Configuring the Polycom ATX System
HDX Soft Remote Right Arrow Button
4 - 3
Advertisement
Table of Contents
