Configuring The Audio; Configuring The Audio Mixer; Verifying The Microphone And Speaker Audio - Polycom ATX 200 Integrator Manual

Polycom ATX Integrator's Guide

Configuring the Audio

Configuring the Audio Mixer

Verifying the Microphone and Speaker Audio

5 - 28
This section describes how to:
• Configure the audio mixer
• Verify the microphone and speaker audio
• Calibrate the Ceiling Microphone Arrays (required only for TIP support)
To configure the audio mixer:
Set Channel 1 Left and Right of the audio mixer to 6db.
1
Set Channel 2 Left and Right of the audio mixer to 8.5db.
2
Refer to the audio mixer documentation for information on how to configure
the Channel settings.
To verify the microphone and speaker audio:
Make sure that the Telepresence Tool is launched on the laptop.
1
Enter the IP addresses of the codecs and enter the passwords (if needed),
2
and then click Connect All to connect to the codecs.
Click the Audio tab.
3
To verify the microphone audio:
4
Click Audio Meter.
a
Polycom, Inc.