Mitsubishi MELSEC-Q Series User Manual page 408

8 DEDICATED INSTRUCTION
Control data
Device Item
(S) + 0 System area
Completion
(S) + 1
status
(S) + 2
Logging
to
specification
(S) + 5
Function
8 - 20
The status of the instruction completion is stored.
0 : Normal completion
Other than 0 : Abnormal completion (Error code) ( 2)
Turn on the bit corresponding to the No. for which logging will be
performed by the LOG instruction.
0: Logging is not performed.
1: Logging is performed by the LOG instruction.
Logging setting No.
((S)+2)
b15 b14 b13 b12 b11
16 15 14 13 12
((S)+3)
b15 b14 b13 b12 b11
32 31 30 29 28
((S)+4)
b15 b14 b13 b12 b11
48 47 46 45 44
((S)+5)
b15 b14 b13 b12 b11
64 63 62 61 60
1 The setting side is as follows.
• User : Data are set by the user before execution of the dedicated instruction.
• System : The execution result of the dedicated instruction is stored by the
programmable controller CPU.
2 Refer to Section 9.3 for the error code.
(1) A command is issued to the logging setting to perform one-record logging.
(2) Regardless of the "Schedule setting" in the logging setting, one-record loggings
of the setting No. set in (S) + 2 to (S) + 5 are performed.
However, high speed logging cannot be specified.
An error will occur if high-speed logging is specified.
(3) Executing the same instruction during execution of the instruction is not allowed.
(The second instruction will not be processed.)
In this case, even if an error is detected, the completion device ((D) + 0) and
completion status indication flag ((D) + 1) do not turn on.
(4) This instruction is not available for interrupt programs.
Setting data
b10 b9 b8 b7 b6 b5 b4 b3 b2 b1
11 10 9 8 7 6
b10 b9 b8 b7 b6 b5 b4 b3 b2 b1
27 26 25 24 23 22
b10 b9 b8 b7 b6 b5 b4 b3 b2 b1
43 42 41 40 39 38
b10 b9 b8 b7 b6 b5 b4 b3 b2 b1
59 58 57 56 55 54
Setting
range
b0
5 4 3 2 1
b0
21 20 19 18 17
b0
37 36 35 34 33
b0
53 52 51 50 49
MELSEC-Q
Setting side
( 1)
System
0, 1 User
8 - 20