Mitsubishi MELSEC-Q Series User Manual page 159

4 SET-UP AND PROCEDURE BEFORE OPERATION
Item
CPU name
PLC series
Multiple CPU specification
Other station specification
Network communication
route, coexistence network
communication route
Save
Back / Cancel
Select access target CPU
setting No. and click on Load
4 - 42
(2) Edit screen
Register the access target CPU.
[Setting screen]
[Setting item]
Sets the access target CPU name. (Within 16 characters)
Sets the programmable controller series of the access target CPU.
Sets the CPU No. when the access target CPU is in a multiple CPU system.
Sets whether other station is specified or not
Sets the network, network No., start I/O address and station No. to be accessed when other
station is specified.
Saves the settings.
The settings are updated when the "Update" button on the Setting update screen is clicked,
the programmable controller is powered off and then on, or the CPU module is reset.
Discards the changed setting and returns to the Access target CPU setting screen.
Loads the parameters of the No. selected in access target CPU setting No. and displays
them on the Edit screen.
(a) CPU name (within 16 characters)
1) Set an access target CPU name.
2) When performing device monitor, tag setting, etc., specify the CPU
name set in this setting.
3) Refer to Appendix 4 (5) for the characters applicable to the CPU
name.
(b) PLC series (QCPU (Q mode), QCPU (A mode), QnACPU, ACPU)
Set the programmable controller series of the access target CPU.
(c) Multiple CPU specification (No choice mode, CPU No.1 to 4)
When the access target CPU is in a multiple CPU system, set the CPU No.
When "No choice mode" has been set, access is made to the control CPU.
Description
MELSEC-Q
4 - 42